Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone, Is AIR-CAP1532I-E-K9 supported with 9800-40 Controller. Do we have a workaround to to connect it to the controller or it is not supported at all?
Hi, I am facing a difficulty we have cisco 2960S switch. The IP telephone is not working, it gets connected and then disconnects. port connected is Gi1/0/43. If we connect direct to the switch then it works. I already updated the firmware of the swi...
I have a new AP. I just entered a wrong config and tried to reset the AP to default factory settings. I am not sure if its in the Rommon state. But its not showing Cisco Controller>. I want to configure it using Mobility express and assign a static ...
Hi I have a switch which is dismounted from production environment. What can I do to copy the current IOS image from flash to tftp server and upgrade the IOS and copy from TFTp server to the switch. Do I have have to fist delete the config to perform...
Hi, I want to Upgrade my IOS version Catalyst 4500 L3 Switch Software (cat4500e-UNIVERSALK9-M), Version 03.05.02.E RELEASE SOFTWARE (fc1). Can I upgrade it to directly 3.11.xE with VSS enabled. Or which version is stable?
If I am upgrading from Version 3.05.02.E to 3.11.0.E. How many upgrades are required. Can I first upgrade all the rommons before installing the new IOS image. Does the Rommon Version: ROMMON 15.1(1r)SG6 supports 03.11.0Eis this agood solution because...
How much time would it need for the reboot. Does it effect the services. If yes then how much time is required if 2 of the devices have to be upgraded to new IOS version.
