Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have several server that have 3 partitions. Each partition has different IP subnet. The servers allow me to reboot and go to any partition I want. Can you please recommend how my switch port (7609) should be configured to dynamically support this c...
Hello, One of my friends was communicating with his friend with whom he lost touch. He received several emails from his friend originating from a specific static IP address (until November 2003). When I look up sites like ip2location.com the locatio...
Hello, One of my friends was communicating with his friend with whom he lost touch. He received several emails from his friend originating from a specific static IP address (until November 2003). When I look up sites like ip2location.com the locatio...
If we have two 15454 MSTPs DWDM boxes, can the east be configured in one box while the west side is configured in the other box?In other words can you have first box with the west config -----------------------------------Slot 1 Line Rx from span fib...
Hello, Can some one please recommend the best possible configuration for ATM. We have OC3 circuits at both the ends, with ATM PVC point to point. What should be the config for vbr-nrt? interface ATM1/0.100 point-to-point ip address 1.1.1.1 255.255.25...
Is there any reconfiguration involved if we upgrade from 4.0.17 to 4.1.1? Also CIFS, pre-positioning etc? Does everything work fine after upgrade? We won't be able to get the disk to all the remotes. So the best thing would be copy ftp install. Does ...
Can you please advise how long it took for you to upgrade per box? Also what version did you upgrade from? What was the upgrade process you used? Did you pre-position the files etc?Appreciate all the help as we are looking to upgrade but are scared t...
Thanks for your response. Can you please help in answering the following questions?Can you connect 6513s or 7613s directly to the 15454 (10Gig) DWDM? What card would that be on 15454 and what interface would that be on 7613?Is configuring a DWDM inte...
Can you please point me to process of installing software for 6513 and clearing all the config so that I can start afresh. I will try to access the switch and get you the info. It does not recognize any except the sup2 mod [mod 1]I also have a switch...
