Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,
I got a multicasting problem while I was testing a stimulated solution. Below is the digram I'm working on. Two layer 3 switches, both are running EIGRP and PIM-SM, and the multicasting server plays a video through VLC Player, then the mult...
Hi there,
I met an issue regarding VSS established on Catalyst 6880-X-LE, please give me any suggestions or comments you have. I appreciate that.
Here is my scenario and configuration as below:
2*Catalyst 6880 are running IOS (c6880x-adventerprisek...
Hey there,
I got a question about vPC when I was watching a demo of ACI on Youtube. The speaker said vPC can be set up between 9396 leafs and Nexus 5548 even without peer-keepalive link between both 9396s or 5548s like the diagram shown. But he didn...
Good news here. I found out the problem I had, which was TTL issue. Actually, TLC player TTL 's default value is 1, also it can not be changed based on the GUI. That would be a problem when the player is using a pim scenario. The solution is to creat...
Hi Paul,
Below is what I got on the client's switch according to you suggestions. Any comments ?
Switch#ping 239.255.255.249 source 192.168.30.1 repeat 10Type escape sequence to abort.Sending 10, 100-byte ICMP Echos to 239.255.255.249, timeout is 2...
Hi Paul
Thanks for your response. Yes, the client can reach to the server's loopback and interface.
I will try " show ip pin rp mapping" tomorrow to see what will be exported.
You mean could be some problems on VLC Player, right? I'm not sure if it...
Oh, BTW, I checked out the document of Cisco. As it mentioned, " If the application sends packets with a TTL value less than 1, you should see the traffic dropped at the first upstream router. To verify, use the show ip traffic command and look for a...
