Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,I'm running HSRP on SVIs on two 3750 switches, the switches are connected together via a l2 etherchannel for HSRP, and a L3 connection. The switches are functioning as mostly layer three switches otherwise running OSPF.When I go to a down...
Hi Guys, (and Gals)I been reading through some of the posts here, and I just wanted to get you opinions or philosophies on the subject of MTU.Say you have the standard MPLS network, and has a service provider you basically have almost everykind of li...
I'm trying to get a Multicast VPN deployed across a MPLS backbone.The CE router has a multicast group, multicast routing enabled and it's interfaces are in sparse-dense mode. The CE is using autorp, (the discovery and annoucement commands) configured...
also for SSH, make sure you don't have an ACL applied to it with the wrong subnet/host address.
Your order is correct. Change the interface first, then OSPF, then BGP. BGP will not advertise a route it doesn't see match the MASK or the network comma...
I don't know if there is any real way you could have avoided this.
Especially if you were SSH to that address, or relied on the OSPF/BGP advertisement to get to the address you used for SSH. I usually use a loopback for management. But again if it r...
I think what your missing is having the iBGP loopbacks (or the interface your using for iBGP peers) needs to be in sparse mode. And you need multicact enabled globaly on all PE rouers.Your also missing Mullticast on the MPLS core. MPLS Multicast cast...
Hi William,Did you get this working? I have a similar setup and want to run my sbc w/Static on a Cisco 3845 router, not on this moto NVG510 with its limited config they gave me.But looking through the docs and info from SBC, I have more questions the...
Thanks, I found the problem this morning. The U's should have tipped me off sooner, but it just didn't register.It was a spoofing filter, they had put on the SVIs, ya I know...daaaa.Anyway thanks for the help, problem resolved...Karl
