so we have 10 digit extensions, that match our DIDs.  we have a person who only wants incoming calls that dial the DID (outside the organization) to pass through to his single number reach configuration.  Is this doable? 

We have an sx20 that we registered to call manager 9.1.2.  we have an ex90 that is tied to our Tandberg gear due to a grant requirement.  Is there any way to get those devices to talk to one another, outside of moving the ex90 over to CUCM?

We are setting up 3 new PRIs on a 2951 with Frontier.  We received 300 DIDs as part of the setup.  The PRIs are registered with CUCM, and they show up on the router.  However, when we try to make an incoming call with one of the new DIDs, the calling...

Is there any way that I can go into our cisco router, and look in the logs to about 2 hours ago and see the number of the call that came in?  On our CID it showed up as unknown, but I didn't know if the router would have captured the actual digits..