Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,currently we are migrating from anyconnect 2.5-2019 to 3.0-1047 used as sslvpn client. While on Windows OS everything went fine I run into issues with Mac OS. Installation via DMG went fine, client is starting well, after I put in the gateway a...
Since I got stucked a couple of times to upgrade a WAE in accelerator mode via the WAAS CM, I'm wondering which is the best way to do this manually via the CLI. The WAE is located via a VSAT connection, which is usually not that stable, so the CM is ...
Hello,we are deploying the CUPC 8.x via Altiris using the MSI. Checked the current available documentation, there is also stated the massdeployment but how to predefince the cups server is not stated -- if I didn't oversaw anything. How can this be a...
Hello,we currently have to postion about 200+ access points in the WCS to generate heat-maps for a lot of floors. Does anyone do have some tipp to "bulk operate" this task? Using the WCS webgui adding the aps step by step ends up a huge workload. Wou...
Good Morning Carsten,I'm now working with following IPSLA + EEM script to work around the issue:ip sla 1
icmp-echo X.X.X.X frequency 5
ip sla schedule 1 life forever start-time now
ip sla reaction-configuration 1 react timeout threshold-type consecu...
Hi Carsten,thanks - same is "working" for me. As soon as the cellular connection is down it will only come up again after a device reload or your described procedure via modem-reset.What is your intention, is this a software/firmware issue (upgrade n...
Hello casper999,would you be so kind and share your cellular config? I do have the same router (C819 with HSPA+/R7) and try to connect to T-Mobile with the same error (Timeout Expecting OK).Thank you in advance.RegardsMathias
Hi Christian,thank you - quite clear, did excatly the same just some minutes before your post. If reverted back to 7.0.5a, which is now working again as expected. Meaning (for documentation propose if other users do run into the same issue):- hw-modu...
