Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there I have just gotten CML personal set up on my PC. My intention is to use CML to prepare for CCNP encore and enarsi. question 1: I believe the standard router and switch images in CML are IOSv and IOSvl2 respectively. When I add one of these...
Hi there I have already posted my query on this forum. However, I have posted it in the wrong section of the forum. Please see my post relating to issues with CML on devnet sandbox at the below link: https://community.cisco.com/t5/cisco-modeling-l...
Hi I have been looking at using the sandbox version of CML2. I have used it a couple of times so far and it has worked OK. However, today, when logging into my session, it is indicating there is some kind of 'System Health Issue' -- in particular i...
Hi there I am looking to get the CML Personal version to help me with my CCNP study. I am looking at the system requirements page at: https://developer.cisco.com/docs/modeling-labs/#!cml-2-1-admin-guide-installing-cml-system-requirements In partic...
I am reading the book Computer Networking A Top-Down Approach. When discussing application layer protocols, the author suggests typing the following commands into CMD in order to see a series of HTTP response messages: telnet gaia.cs.umass.edu 80GE...
Also, one extra question in addition to the two I have already asked above!! When I click on a node in my topology, I am currently unable to delete it, because the 'Delete Node' button is grayed-out (see screenshot below). Does anyone know what I ne...
***** I have just realized that I might have been better to post this question in the Devnet Sandbox section of the forum, Therefore I don't suppose a moderator would be able to relocate this post to the Devnet Sandbox version of the forum? ****
Still no luck. Have turned off my anti-virus software, disabled firewalls. Installed all available Windows 10 updates. Also run the command chkdsk /r which apparently can fix some stuff ... Still getting same issue, it just freezes upon loading u...
Just as an update, please note that I decided to uninstall the above version of packet tracer (7.2.2.417 ) and install version 7.3. As before, the application just freezes once the schematic screen loads up. Event viewer is now providing the follow...
