Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,we would like to upgrade our UCM cluster from release 4.1(3) to 8.0(3) using new hardware. Unfortunately there is no DMA tool available on cisco.com to migrate configuration and no specific upgrade guide from release 4 to 8. Does anybody have some...
Hi,we do have a pair of AIR-BR1310 connected together at about -55dBm. Everything looks fine but if we are transmitting data over this link we can see crc errors rising up quickly on the radio interface of one of the bridges. On the other side there ...
Hi,we are using the Secure Service Client in our WLAN. Now we have some ethernet clients that we want to connect to the WLAN through a WGB. I'm now looking for a WGB where we can install the secure service client on. Does anybody know such a solution...
Hi Bernhard,you can use the 3 x 3 offer to upgrade from 4.x to 8.0x.Starting from the CUCM-USR you than configure into this container migration users.RegardsGundolf.
Hi Andre,many thanks. We have done the Carrier Noise Test and than selected the least congested channel (appr. 5%). So I think this should be ok.Could it be a failure within the radio interfece itself?Thanks and regardsGundolf.
