Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiCan someone confirm if the protected edge port feature for the 2960S will work across all stack members? I know this feature is usually locally significant but it would be nice to know it works across all stack members.Thanks in advanceAdrian ...
Hello Netpros.Whilst attempting to perform a standard enable password recovery on an 803 router, I discovered that a ROMMON password had been set. This had the significant disadvantage in that I could not set the config register to bypass the configu...
Hi Under Mobility Express 802.11ac Access Point Wireless settings, you can configure the Channel and Channel Width. If you are deploying a number of AP's or you see a lot of competing AP's on your channels or you see a lot of non-802.11 RF noise, th...
It would appear you are using a different data rate when connected to the 1832 vs the Zyxel. When connected to the 1832, your data rate is equivalent to MCS 8 on a 20Mhz channel. When connected to the Zyxel, it's MCS 9 on a 80Mhz channel. You can see...
Hi
The first ports in each port group are outlined are the lowest port IDs in the port group allocations.
If you refer again to the link you provided initially, it lists the 8 port groups. Interfaces 1, 2, 9, 10, 17, 18, 25 and 26 are the first port...
Order a license through normal Cisco sales channels and processes. The product must be activated by installing license “keys." After purchasing a software feature, you will:Receive an email with the Product Authorization Key (PAK) or you can receive ...
Hi
Yes all the ports on the 3850XS use SFP+. You mentioned these will be copper and presently Cisco only offer Fibre Optic 10G SFPs or direct-attach Twinax 10G cables up to a distance of 10-15m (from memory). I'm not aware of a Cisco 10G copper SFP ...
