Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I've been asked to configure VRF's using VRF lite on our LAN. Could someone please point me in the right direction for an example of a basic setup/configuration.Best WishesSteve
Hi,I'm due to connect a 2nd WAN link to the same destination. The routers are 1601's and have a spare WIC slot which I'll furnish with a WIC-1T. We wish to either bundle the two links together or run load sharing across the two. Does anyone have a...
We have a single router on our LAN that is for third party connections. I want to run OSPF for these connections so that the routing is dynamic. However I want to stop each 3rd party receing eachothers networks - what options do I have??
Hi,Have you considered using a lab across the internet - if it's cost effective to do so - it would save all the trouble of purchasing the equipment ??Let me know, as I may be able to help you out
I recently upgraded SupII to Sup720's on a considerable number of 6500's. The slot numbers will change from 1/2 to 5/6. We needed to upgrade our PSU's to 3000W 16Amp power supplies. Fan tray upgrades were required together with using the 6500-E cha...
Hi Avil,Yes you would have to run OSPF between ROUTERA through to ROUTERE.If a firewall is between them then you would need to allow the OSPF protocol through the firewall.Question for GlobalNettech -In the setup as provided by Avil - ROUTERA----ROUT...
I have a lab that can be accessed over the internet. It contains 4 switches (2x5500, 1x2950,1x3500), 2 RSMs for LAN routing, 2 WAN routers, FR, P2P Link and ISDN. If you're interested email me on steve@swaters.co.uk and I'll send additional informa...
