Hello, I am working with a Cisco SPA232D that has been factory reset and put into Bridge mode.
I am trying to register it to a Digium (Switchvox) phone system. I have set the registration password for the extension set on the Digium and am putting in the proxy IP, the Display Name, the User ID, and password into the Cisco. But the phone doesn't seem to register with the Digium or really even have any kind of conversation with it. After setting it to Bridge mode I found that the Ethernet port no longer works necessitating connecting the cable to the Internet port (in case that is relevant).
I have registered quite a few regular Cisco handsets (SPA514G) using the same sorts of settings, but they don't seem to work on this device. Is there some arcane setting I'm missing? Any advice would be greatly appreciated.