Cisco UC520 Configuration

[lee.woods16091]

Hi Guys, 

i have recently purchased a cisco uc520 which hasn't yet arrived, 

i'm struggling to find any information on configuring this device, i'm not familiar with the command line interface. 

is there any other way of configuring the device or can anyone help with the command line side of things? 

thanks in advance :) 

Lee 

[Brandon Buffin]

You can find Getting Started/Quick Start guides here:

https://www.cisco.com/c/en/us/support/unified-communications/unified-communications-500-series-small-business-uc500/products-installation-guides-list.html

One option is to use Cisco Configuration Assistant to configure. CCA has a GUI interface and can configure the basic components (DNs, call routing, VM, etc.)

https://software.cisco.com/download/release.html?mdfid=281010085&softwareid=281161599&release=3.2(3)&relind=AVAILABLE&rellifecycle=&reltype=latest&i=rm

As I'm sure you are aware the UC520 and CCA are no longer Cisco supported products.

Brandon

[lee.woods16091]

hi Brandon, 

do you havce any idea on how i connect the uc520 with the configuration assistant without a console cable? 

regards, 

Lee :) 

[Brandon Buffin]

The default configuration of the UC520 has a DHCP server configured to hand out addresses in the subnet 192.168.10.1/24. You would connect your PC to one of the switchports and connect to 192.168.10.1 via CCA. If the default config has been wiped, you will need to connect via console cable to assign an address and setup a username/password before connecting with CCA.

Brandon