1) I am trying to have the unite factory default and was following an instruction to do it via CLI.
2) But in order to reset the CUE, it seems I have to get into the CUE session mode. I can not do this as it says it needs IP address configured on ie0/0.
3) I was following instructions offered by @yahsiel2004 in https://community.cisco.com/t5/unified-communications-infrastructure/can-not-access-cue-on-uc560/td-p/2454559 .
4) The router would not accept #service-module ip address xxx.xxx.xxx.xxx 255.255.255.0
The following is the current readout from the running config.
Would anyone please help me set the router to the factory default so that I may access the router via CCA?
Thank you very much.
****** Start of partial log ****************
interface FastEthernet0/0
no ip address
duplex auto
speed auto
!
interface Integrated-Service-Engine0/0
ip unnumbered FastEthernet0/0.1
!
interface FastEthernet0/1/0
no ip address
!
interface FastEthernet0/1/1
no ip address
!
****** End of partial log ********