UC560 with WAN desactivated unable to route VLAN100 and 90 to Internet

[Simon Robert]

Hi,

We are moving our old UC560 to a house thats only have satellite Internet. Unfortunately, the provider (XPlornet) does not provide access to BridgeMode on their modem router. To avoid Double Nating, i have desactivated WAN port and use the Modem as the router and VLAN and DHCP provided by the Cisco UC560 (IP Tel Router)

So, my satellite modem is : 192.168.10.1

UC560 Data Vlan1 : 192.168.10.2

UC560 Voice Vlan100 : 1.1.1.0 

CME Vlan90 : 10.0.10.0

I have put a static route : 0.0.0.0 0.0.0.0 192.168.10.1 to allow the UC560 to get out to the Internet.

The problem is : it's only works with the Data VLAN. The voice and Cue VLAN does not ping Outside.

Does anybody know how to allow the Voice VLAN to use the gateway 192.168.10.1?

I have put ACL Rules but it does not seems to work.

NAT and Firewall are disabled. And Wan port too.

Thanks for your help.

[Dennis Mink]

probably set a static route on your modem to point back to the vlans 100 and 90 via 192.168.10.2

[Simon Robert]

Thanks Dennis for the fast answer. Unfortunately, I don’t have any routing tools possible with the modem. Everything is blocked inside the configuration web interface.