I'm running multiple CCME setups and am finding that all my fixed phones (7911/7931/7961/7965/7970) retrieve their time-zone information from the telephony-service section on the CCME router, which works fine.
However all my wireless phones (7921/7925) seem to show the same time as the router, and do not seem to pick up a time-zone at all. They just show the default time zone (UTC) when I check from the web interface of the phone.
The problem with this is we like to keep all our network infrastructure running on the same time-zone, but of course want the phones to display the time relevant to the local area.
This command works with the vendorConfig section of the Sep*.conf.xml configuration file, which is read by the phone firmware when the Cisco IP Phone is booted up. Certain phones, such as the Cisco Unified IP Phone 7906 , 7911, 7931, 7941, 7942, 7945, 7961, 7962, 7965, 7970 , 7971, and 7975, obtain Coordinated Universal Time (UTC) from the clock of the Cisco router. To display the correct local time, the time display on these phones must be offset by using this command.
This command is not required for Cisco Unified IP Phone 7902G, 7905G, 7912G, 7920, 7921, 7935, 7936, 7940, 7960, or 7985G.
For changes to the time-zone settings take effect, the Sep*.conf.xml file must be updated by using the create cnf-files command and the Cisco IP phones must rebooted by using the reset command.
IntroductionFeature EnablementMirroring explainedConfiguration & VerificationLimitations
Prior to Cisco IOS XR Software Release 7.1.2, XR dual RP devices did not support file mirroring from active RP to standby RP. Administrators ...
Hi Everyone, Would like to extend my thanks in advance for anyone offering assistance. As the subject hints, anyone here know of a way to convert IOS configs to XR config? I seen and heard about SOX tool but i am unable to find it. I also tried ...
When I run the command 'sh controllers fabric fia q-depth location 0/0/CPU0' or any 0/X/CPU0 and see the following, what exactly does it mean? RP/0/RSP0/CPU0:Router#sh controllers fabric fia q-depth location 0/0/CPU0********** FIA-0 **********Categor...
Symptoms: the root password can't log in by GUI Solution:1) login CLI as admin2) write command "ncs webroot enable" without qutations3) we can check the status by "ncs webroot status" hope this will help someonethanks
ISO images are as close as we can get to the old school classic IOS images from back in they day.
Doing upgrades by putting a new image on the flash, changing the boot pointer and reload was and is still the walhalla of Cisco based devices.