call outbound to pstn with E&M

[paulojunior]

Hi,

I want to configure call telephonic for is of my branch office through voip. As it would be the configuration for this with modules E&M and FXs.

site 1 with fxs

site 2 with E&M

[spremkumar]

hi

hope these links may help u out in configuring u r modules...

http://www.cisco.com/en/US/products/hw/routers/ps221/products_configuration_guide_chapter09186a0080089517.html

http://www.cisco.com/en/US/products/sw/iosswrel/ps1828/products_configuration_guide_chapter09186a00800ca621.html

regds

prem

[paulojunior]

hi, thanks for your answer, but I have some doubts:

I have a site with 2600 router and the other with router 3640. In router 3640 it has 4 ports FXS and in router 2600 I have 4 ports E&M.

No I understood with making configuration of dial-peer for outbound call directly you the PSTN, being that PBX this hardwired with the PSTN.

which caracter I must use in configuration of dial-peer so that router it understands that the call must be transferred to one conexao with the PSTN?

Best regards.