06-24-2004 07:36 AM
hi there, just enlighten me on cisco ATA 186 back to back config, my network is like:
phone---ATA----Switch---ATA---Phone,wnat to know the sample config, if this not possible, fine ,then let me know what shud i configure to get a dial tone,as im getting a busy tone than a dial tone, or lastly what shud i do to reset the ATAs to factory default settings,
cheers
shukky
06-24-2004 05:41 PM
If your ATA is running skinny right now then I think it is not possible (because no callmanager in the picture).
But if you load your ATA with a SIP image then in the SIP proxy filed, you can specify the IP address of the other SIP ATA and then you should be able to call from one ATA to another.
I haven't tried that with the ATA, but done with the 7940 phones and it worked.
To get the dial-tone, you must configure a number for the ATA first. (UID)
To reset the ATA for factory defaults
http://lists.digium.com/pipermail/asterisk-users/2003-August/017474.html
Hope this would help.
Thanks
06-27-2004 07:43 AM
thanx sali
i got it, now secondly, when im using a gatekeeper (cisco3640) , when the call is made the bandwidth shown on the show gatekeeper calls,its showing being used is 64kbps, if lower the bandwith to 60, on the gatekeepr menu, the call doesnt go, so i need some compression feature, so just let me know.
regards
shukla
06-27-2004 11:13 PM
you can use the g.729 codec that would nee approx. 20 kb per call with overhead included.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide