07-28-2004 07:32 AM
Hi all, I have implemented the following configurations in my system.
When I do this, all the calls are going to gatekeeper without matching any prefix or any other parameter. Apart from the dial-peer listed here, I have got three more dial-peers from where I want to send the calls to different gateways.
Question is, How do I divert only specific traffic, to GK and the rest of the traffic should pass through other dial-peers as normal ?
1) voice rtp send-recv
2) call rsvp-sync
3) interface FastEthernet0
h323-gateway voip interface
h323-gateway voip id gk1 ipaddr x.x.x.x 1719
h323-gateway voip id gk2 ipaddr x.x.x.x 1719
h323-gateway voip h323-id zeko6
4) dial-peer voice 1 voip
destination-pattern 00T
session target ras
dtmf-relay
codec g729br8
no vad
Regards,
Kiran
08-03-2004 08:29 AM
Hi Saeed,
As far as my knowledge goes, there is no such software for Imate.
08-03-2004 08:51 PM
Kiran,
There's another option for you.
You have to configure the GK correctly on the GW,
verify the succesfull registration and then
you can combine the dial-peers as usual as per example below:
dial-peer voice 2 voip
incoming called-number .
destination-pattern .T
voice-class codec 100
session target ras <- going to configured GK
dtmf-relay h245-alphanumeric
fax-relay ecm disable
fax rate 9600
fax nsf 000000
fax protocol t38 ls-redundancy 1 hs-redundancy 1 fallback none
!
dial-peer voice 13 voip
preference 4
destination-pattern 072.......
session target ipv4:217.19.0.22 <- specific GW1
!
dial-peer voice 14 voip
preference 5
destination-pattern 074.......
session target ipv4:217.19.0.16 <- specific GW2
etc...
Hope this will help you.
Regards,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide