Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, can we change the TFTP server address on a cisco 79xx phone remotely? I know we can use the SEP<mac>.cnf file to configure, but can we also change the TFTP address using this file. The problem we have is we are changing the IP of our SBC and i...
hi all, We are facing voice quality problem in cisco as5400 when a call is originating from IP and terminating to PSTN and also the other way round. However in PSTN to PSTN the voice quality is good. Pls have a look the attached configuration fi...
I want to send the destination number, dnis and ani in a single call setup to the telco so that The telco would authenticate the call based on DNIS, send the call to the DESTINATION and presents the ANI.I want to hardcode the DNIS in the cisco. ANI a...
Hi,I have a cisco AS5300 Access Server. It was working fine for ages. Suddenly, after a restart, it is showing initial configuration dialog. I tried to configure it again and saved the configuration. I have copied the running config to start up confi...
Hi all, I have implemented the following configurations in my system.When I do this, all the calls are going to gatekeeper without matching any prefix or any other parameter. Apart from the dial-peer listed here, I have got three more dial-peers from...
George, thanks for that. But we don't have control over the DHCP servers of our customers. This appears to be a beautiful solution that we have never tried before. I will give it a try. But at the moment, as we don't have control over our customers' ...
