cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1077
Views
0
Helpful
1
Replies

IAD2432 T1 Loopback & Bert Test

George Spanos
Beginner
Beginner

I have an IAD2432 running IOS 12.4(24)T6.1. We are using the IAD for SIP->PRI conversion to legacy PBXes. I am trying to find a few tests to run on the T1 to confirm it's running clean. I found a way to put a T1 Loopback (local & remote) but I can't figure out how to run a Bert Test. Any ideas?

1 Reply 1

paolo bevilacqua
Hall of Fame Master Hall of Fame Master
Hall of Fame Master

It may not be able to run BERT.

Just configure it right and observe show controller T1.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers