03-02-2018 08:25 PM - edited 03-01-2019 02:06 PM
I have two Vg224. And i use it only internal calls without CUCM. One of them 100,101....123, and another one 200,201,...213. Its working fine in own side. But i can not call from vg1 to vg2.
How to solve this issue?
Please, help!
Solved! Go to Solution.
03-07-2018 04:34 AM
03-09-2018 01:42 AM
03-05-2018 07:48 AM
03-05-2018 09:10 PM
@R0g22 wrote:
Are these VG's registered to CUCM either as SCCP or MGCP ?
No. Its not connected CUCM. Both Vg224 connected each other by LAN cable.
03-06-2018 04:04 AM
03-06-2018 08:22 PM - edited 03-06-2018 08:24 PM
I used these commands.
!
write erase
reload
! after reload
conf term
!
hostname rtr_201
!
interface FastEthernet0/0
ip address 10.22.33.201 255.255.255.0
!
dial-peer voice 20 pots
destination-pattern 200
port 2/0
!
dial-peer voice 21 pots
destination-pattern 201
port 2/1
!
end
this is my config.
In the attachment vg224 config.
03-07-2018 04:34 AM
03-09-2018 01:42 AM
Great job!
Its working.
Thank you for support!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: