I have a question about CCME 4.0 and multiple E1 connections.
In my configuration, I have two E1 connections each with their DID numbers. I am assuming that I will need a VOIP dial peer for each with the appropriate port 0/1/0:15 for the first E1 and port 0/2/0:15 for the second E1.
My question is about outbound calling, and does CCME able to use both to pots dial peers? Is there a way to have a route group as in CCM? Or do I have to have translation profiles built so that I can "split" the outbound calls dependent on the VOIP phone calling outbound?
Thanks
Dennis.