Need configuration

[chiragdhot]

Hi friends,

I am going to setup a voip solution for my company.We are using 3640 cisco routers on our both ends. I am attaching a diagram of our network. Plz give me the configuration of the scenerio.Plz give the config of t1 and e1 and mainly dial peers.t1 line is a t1 not a pri t1.

Thanks in advance

[qz01593986]

try this config.

controller E1 1/0

pri-group timeslots 1-31

!

!

interface Serial1/0:15

no ip address

encapsulation hdlc

no logging event link-status

isdn switch-type primary-net5

isdn overlap-receiving T302 5000

isdn protocol-emulate network

isdn incoming-voice voice

isdn T310 60000

isdn send-alerting

isdn sending-complete

isdn incoming alerting add-PI

no cdp enable

!

!

voice-port 1/0:15

echo-cancel coverage 32

echo-cancel suppressor

timeouts interdigit 3

!

!

dial-peer voice 9 voip

destination-pattern 0T

translate-outgoing called 1

voice-class codec 1

session target ipv4:144.44.205.100

dtmf-relay h245-alphanumeric

fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback cisco

ip qos dscp cs5 media

no vad

!

dial-peer voice 8 pots

destination-pattern 0T

direct-inward-dial

port 1/0:15