cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
430
Views
0
Helpful
1
Replies

PARK FXS

mjgarate
Level 1
Level 1

Hi,

I have got an HD_NMV (2610XM) and VIC-4FXS(1751-V) port which is showing as FXSLS_PARK under 'show voice call summary', we already replace the cable, the routers(just in case hardware -dsp, cards-), the ports in PBX and the problem persists. we have two routers: one 2610XM and a 1751-V. Both router are connected to Ericsson PBX BP250 and we can see in both routers FXLS_PARK.

My port configs.

voice-port 2/1

no supervisory disconnect lcfo <-- Try with and without it.

disconnect-ack

idle-voltage high

echo-cancel coverage 32

cptone MX

timeouts call-disconnect 3 <-- Try with and without it.

timeouts wait-release 3 <-- Try with and without it.

caller-id enable

no battery-reversal <-- Try with and without it.

!

voice-port 2/2

disconnect-ack

idle-voltage high

echo-cancel coverage 32

cptone MX

caller-id enable

I'll appreciate your help.

Thanks and regards.

-Mario

1 Reply 1

Chester Rieman
Cisco Employee
Cisco Employee

Check the wiring and voltages:

http://cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a008011c7f3.shtml

Should idle-voltage really be set to high?

Are you sure it's loop-start?