cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1910
Views
0
Helpful
2
Replies

SIP TRUNK BETWEEN CME AND TRIXBOX

Jesutofunmi O
Beginner
Beginner

Hello Guys,

 

I'm trying to setup a simple SIP trunk between my CME which uses Cisco 7945 phones and Trixbox which uses Grandstream phones at different stations with LAN to LAN VPN setup. Its been unsuccessful as the trunk seems NOT formed at all. Please see config below;

 

CME

sip-ua
no remote-party-id
retry invite 4
retry response 3
retry bye 2
retry cancel 2
retry register 10
retry options 1
timers connect 100
registrar dns:mydns.com expires 3600
sip-server dns:mydns.com
host-registrar
!

*FOR OUTGOING CALLS (TRIXBOX EXTENSION NUMBER IS 2XX)*

dial-peer voice 100 voip
destination-pattern 2...
session protocol sipv2
session target ipv4:192.168.0.120
dtmf-relay sip-notify
codec g711ulaw
no vad
!

FOR INCOMING CALLS (NUMBER RANGE FOR CISCO PHONES IS 3001-3061)

dial-peer voice 200 voip
session protocol sipv2
incoming called-number 30...
dtmf-relay rtp-nte
codec g711ulaw
!

 

telephony-service
sdspfarm units 10
sdspfarm tag 1 NKH-CONF-BRDG
conference hardware
max-ephones 165
max-dn 200
ip source-address 172.16.121.5 port 2000
timeouts interdigit 4
system message NKH
url directories http://172.16.121.5/localdirectory
cnf-file location flash:
cnf-file perphone
load 7945 SCCP45.9-2-1S.loads
time-zone 23
date-format dd-mm-yy
max-conferences 8 gain -6
web admin system name admin secret 5 $1$LQHI$xoKPZc.Lr61jZiz651SGy1
dn-webedit
time-webedit
transfer-system full-consult
create cnf-files version-stamp Jan 01 2002 00:00:00

 

 

 

 

FOR TRIXBOX

SIP TRUNK SETTINGS

Outgoing Settings

Trunk Name: ConnectionToCME

PEER Details:

host=172.16.121.5
type=friend
qualify=yes
nat=no
allow=gsm&ulaw
insecure=very
fromdomain=172.16.121.5
dtmf=rfc2833
disallow=all
context=from-internal
canreinvite=no

 

 

Incoming Settings

User context: 172.16.x.x (IP address of CME)

USER Details:

host=172.16.121.5
allow=gsm&ulaw
type=friend
qualify=yes
context=from-internal
nat=no
insecure=very
fromdomain=172.16.121.5
dtmf=rfc2833
disallow=all
canreinvite=no

 

 

Outbound Routes

Route Name: ConnectionToCME

Dial Patterns: 30

Trunk Sequence: SIP/ConnectionToCME

 

 

1 Accepted Solution

Accepted Solutions

Its working now. 

 

Thank you.

View solution in original post

2 Replies 2

Daniele Giordano
Collaborator
Collaborator

Is the VPN up? Can you ping the trixbox lan IP from the CME ?

If yes, can you ping a grandstream phone from CME?

If yes, enable a debug on CME (debug ccsip messages) and  try to call.

Please, share your results here.

 

Regards.

Its working now. 

 

Thank you.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: