Which Signalling to use with NORTEL SL100

[senthil]

Hi group

I have to configure interoperability between NORTEL SL100 running release software MSL-17 with Cisco 3745

with NM-HDV2-2T1/E1..

My question is, what are the T1 signalling options supported in this scenario ??

Can SL100 provide ISDN PRI or Q.SIG Network Side emulation ???

And are there any limitations with the T1 PRI Line Card model / version and supported signalling types.

Appreciate some feedback..

Thanx

Senthil

[pacameron]

SL100 is an older Nortel box, in the past we have made them work with IOS gateways b changing the switch type on gateway to dms-100 and set pbx to sl100, the PBX also needs the trunks set up as a tie line.

You may also need to add ths command to the router D channel config to get around an issue with some Nortel switches messing up the channel ID -

isdn channel-id invert extend-bit

[senthil]

Hi

Thanks a lot for the information...

Do you have any idea about the software release version of SL100 with which this scenario is tested.

Bcoz I don't find any documents on CCO, specific to SL100..

TIA

Senthil

[pacameron]

Sorry - can't help with the Nortel details - you may need to speak to their tech support for this kind of information.