PREFACE:: I am a 20 year veteran of Microsoft/Windows Infrastructure Engineering and a Novice (at best) telecom guy, so if you have advice on what I need to look for next please be very specific or please point me in the direction of specific documentation that will help me through any CLI/terminal stuff for the gateway/router.
Hey guys!!!
I have implemented 10 digit route pattern in our CUCM 12.x system for the upcoming 10 digit dialing plan change on Oct 24 for our area code. I have done both of the following in our Route Pattern Configuration:
9.[2-9]XX[2-9]XXXXXX
&
9.600[2-9]XXXXXX
Neither is working.
I have read that since we are using H.323, there might have to been changes to the dial-peers on the router. But with Cisco's documentation being overwhelming and sometimes not to the point, I am having a hard time tracking down the specific commands I need to run to make these changes.
Any advice would be great.
Sincerely,
Lt. Slothrop
