Big thanks for taking your time and replying, i have tried to answer your question the best i can, i will try to get a hold of the IT department for some of the questions and update after that.
The objective of using the SPA112 Analog Terminal Adapter is to enable the connection of the intercom system's output to a distant cellphone connected to one of the cellular networks.
Basic Review:
Cabling:
The intercom system's analog output is designed to connect to a telephone network and dial a number? Using a cable with an standard RJ11 connector you have connected the intercom system's output to the SPA112's "Phone 1 or Phone 2" port. Is this correct? Correct, i have connected the RJ11 cable to the Phone 1 output, however, the intercom system dont have an RJ 11 output but 2 screws which the line comes out of, i have connected the 2 middle cables in the RJ11 cable to these screws. I can tell under the voice tab and information that the ATA is trying to dial the correct phone number that i want it to dial, so i figured this is working.
The SPA112's "Internet" port is cabled to a distant router that attaches to a local network and the internet. Correct? The "Internet" port is cabled to a network switch which i have gotten a port configurated for the ATA by the IT department, this is probably where the problem starts. I have asked the IT department to open up port 5060 TCP for the SIP protocol and port 16384 UDP for the RTP protocol in the firewall, between my ATA and the SIP server they have handed me.
The SPA112 is cabled to a local power source. Yes
Configuration:
To connect to a telephone number in a cellular network you need to go thru a sip server that can pass the call to the cellular network. This would be a voip service or a PBX server that has a connection to a voip service. What kind of service are you connecting to? Is it located at a local IP address or an external IP address? I actually dont know, i have gotten information handed to me about their already existing SIP server they have set up for a similar intercom system at another building. I will check with the IT department when i can get a hold of them about this.
You have configured Line 1 or Line 2 Tab (depending on the cabling from the intercom system).
You indicated that you set Make Call Without Reg: Yes The Sip Server accepts unregistered calls? Is this correct? That i have to check with the people administrating the SIP server.
On the Line Tab you have configured
Proxy: (Domain Name or URL)
User ID: xxxxxxx
Password: xxxxxxxx
Is this correct? Yes this is correct, the company that owns the apartment buildings have a SIP server set up for this from earlier buildings. I have recieved information from them including server IP which i have set into the proxy field, account id which i set in the User ID field and password ID which i put in the password field.
I am sorry, i couldnt get the syslog to work, i guess the ata cant connect to my computer due to the firewall. I downloaded the local log from the ATA if that says anything to you, i think i made like 3 calls within the log time.
