Cisco AP521G on UC520

[final-reseaux]

How can i configure an Access Point Cisco AP521G on UC 520 with CCA 2.0? I see the AP, the smartports is configured on acces point on the fa/0/1 but they have no ip address, what is the problems?

Regards

[Steven DiStefano]

I just set this up a few weeks ago.   Check out this document.  I take you through all CCA screens.  The only part you have to do in advance is WLC526 initial setup.  I didnt revisit this in CCA 2.0, but would be interested if you notice any changes....

https://www.myciscocommunity.com/docs/DOC-6679

[final-reseaux]

I have resolved the problems but an other is coming. When i have no security on the ap, i can connect no problems but when i want to securit them with wpa-psk or wep i can't authetificate? What is my problems?

Regards

[final-reseaux]

Nobody have an idea? Why i can't connect when i install wep or wpa?

[Steven Smith]

You might look at ASCII vs HEX keys.  CCA does ASCII, you should check to make sure that your are using ASCII on the clients.

[final-reseaux]

thanks steven but where i can see this in the client?

Regards

[Steven Smith]

The depends on the software being used to control the wireless card.  Usually there would be a button where you enter the WEP or WPA key that would say ASCII or HEX.