Dial-peer challenge

[malinton]

All,

I have 1 UC520 and 1 3825. The following is configured and works fairly well...

1. Extension to Extension between both devices.

However, when I try to transfer an incoming call from the 3825 to the UC520, it strips the first digit, 3.

The 3825 (CME1) is connected via VLAN to another PBX, asterisk, at another location using a 2.. dial-peer session target..see the  dial-peer configuration

below:

CME1

1001   voip  up   up                                0  syst                    

2000   voip  up   up             2..               0  syst ipv4:192.168.3.251 

2999   voip  up   up             299              0  syst ipv4:192.168.3.251 

30001  voip  up   up             3...              0  syst ipv4:192.168.7.45  

3301   voip  up   up             3301            0  syst ipv4:192.168.7.45  

7001   voip  up   up             7001            0  syst ipv4:192.168.200.2 

5555   voip  up   up                                0  syst                    

5556   voip  up   up                                0  syst                    

5557   voip  up   up                                0  syst                    

6666   voip  up   up                                0  syst

UC520

30003  voip  up   up             [4-5]...           0  syst ipv4:192.168.1.250

2000   voip  up   up             7000               0  syst ipv4:10.1.10.1

2012   voip  up   up             3301               0  syst ipv4:10.1.10.1

2001   voip  up   up             7001               0  syst ipv4:10.1.10.1

Extensions for CME1 is [4-5]...

Extensions for the UC520 is 32..

When an incoming PSTN call is transferred from CME1 to UC520, it strips the 3 from UC520 numbers.

If a call is made directly, 3203 for eg. it goes thru ok.

How is the best way to correct this problem.

[paolo bevilacqua]

That you look at configuration and fix translations as necessary.

[malinton]

Well, thanks Paolo...I know I am missing something here....however, I am not seeing it, hence my posting on the site ...

[paolo bevilacqua]

Well, we can't see it either, as at this time you configuration is visible to you only.

If you are the end user, what not give the job to a reputable consultant or UC certified Cisco partner? He/she will make everything work and save you much time and frustration.

[malinton]

Paolo, please suggest to me what aspects of the configuration i should post ..I have seen posts with much less than I have posted and forum members post tips, or suggestions etc...the dial-peers I have posted is where I am having the challenge...I am the 'end user' and also charged with making this thing happen ...all this has been working  because I have been doing it...obviously, i am missing something..but if you would prefer to not help, then do not respond..no need to be that way ...

[danplacek]

Please post the entire configuration with any passwords removed.

The output from "debug voice ccapi inout" and "debug translation" wouldn't hurt either.