Distinctive Ring for Internal and External Calls

marknesbitt · ‎08-25-2009

Can you please tell us how to make the ring different when a handset recevies an internal call as opposed to an external call.

David Trad · ‎08-25-2009

There is a guide here to do it:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmering.pdf

However this will require some CLI work doing it via this method.

Cheers,

David.

Cheers, David Trad. **When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) *

aureliensoyez · ‎11-30-2009

Hello !

I have the same pb with my UC500 and my 7965 phone.

I have read the document but when i change the settings, that's not work... ring stay every time the same.

What's the diffrencence between Defaut Ringtone (Choice 1 on User Settings on the phone) and the Choice 2 (with my phone number) ?

Thx a lot.

Bye

Marcos Hernandez · ‎12-16-2009

One setting specifies the default for all lines, while the second (or third, or fourth, etc.) allows you to specify a ring tone per line.

Marcos