06-23-2009 07:32 AM - edited 03-21-2019 01:14 AM
Hi,
i have some problemx with a fax, incoming fax in error, i get just some part of the fax and i had an error.
I have configured them with CCA 2.0 analog port fxs 0/0 is in mode "FAX" signal "loop start" extension "301"
Some fax are good and other are incomplete, what can i do?
Regards
06-23-2009 08:16 AM
What is the PSTN connection? Is it a SIP trunk?
Thanks,
Marcos
06-23-2009 08:23 AM
the pstn connection is BRI french numeris
06-23-2009 08:29 AM
Please attach a "show run". Don't forget to hide the passwords/
Marcos
06-23-2009 08:33 AM
06-23-2009 08:45 AM
Please try the following configuration
!
voice service pots
fax rate voice
!
Let me know if that helps,
Marcos
06-23-2009 08:46 AM
where i copied this line?
06-23-2009 08:48 AM
Tenet to the UC500 (192.168.10.1), login and then enter configuration mode by typing "conf t". Enter the commands I gave you earlier and then type "exit". Finally save your config with "write mem".
Marcos
06-23-2009 09:15 AM
invalid input detect when i type voice service ports
06-23-2009 09:33 AM
It is "voice service pots", not "ports"
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide