France Telecom configuration

[Marc Montouchet]

Hi there,

I'm new on this forum and also new on Cisco community.

Just 18 years of engeneering in computers, software and networks...

We're looking for a standard configuration of an UC540 / Bri connected to two France Telecom/T0.

All the configuration of the UC540 has been done and work perfectly on our Msft Network except the most important thing the PSTN Trunk.

We've 2 T0 with 10 SDA (DID) and would like to test Cisco products on such configuration.

Can somebody help us with this configuration, may be with a sample standard one ?

Thanks in advance

Marc

[gondange1]

Hello,

you must use this configuration for FT :

interface BRI0/1/0

no ip address

isdn switch-type basic-net3

isdn point-to-point-setup

isdn incoming-voice voice

isdn sending-complete

trunk-group ALL_BRI 64

!

interface BRI0/1/1

no ip address

isdn switch-type basic-net3

isdn point-to-point-setup

isdn incoming-voice voice

isdn sending-complete

trunk-group ALL_BRI 64

For DIDs, only the four last digits of the called number are transfered, so you must add transfer rules like this :

1234 -> 201  if the called number is 01 XX YY 12 34 for instance.

This can be done in CCA or by simple translation rules like this :

voice translation-rule 9

rule 1 /1234/ /201/

Stephane

[Marc Montouchet]

Hello

Thanks a lot for your answer.

I'm on travel this week so I'll try that on friday.

Again thanks

Regards

Marc

[Marc Montouchet]

Hi Stephane,

I did as you suggested and outgoing calls seem to work.

It's impossible to get incoming calls and every calls get a busy tonality from the outside...

Any idea ?

On our old system all DIDs were wtih 6 digits 68xxxx or 77xxxx is that right ?

Thanks for your answer

Regards

Marc

[gondange1]

Non les DID ont juste 4 chiffres avec le numeris FT.

Il faut utiliser les 4 derniers chiffres du numéro pour router les appels dans l'UC500.

[Marc Montouchet]

Bonjour,

En fait après avoir fait un "debug isdn", j'ai pu router mes appels à partir des ... 9 chiffres ... transmis par FT pourquoi 9, je ne sais...

Toujours est il que depuis que j'ai recréé mes règles à partir de cette constatation, cela fonctionne fort bien.

En tout cas merci de votre réponse

Marc

Hi,

In fact after a "debug isdn", I could create the right rules based on 9 digits numbers trasmitted by FT why 9, I don't know

Then as I created my rules on this obesvation, it seems to work pretty well.

Thanks again for your answer

Marc

[final-reseaux]

Bonjour Marc,

merci de venir à mon aide, peux tu me dire comment voir sur mon debug isdn, le nombre de digit en sortie.

Cordialement, Fabien

[Mohamed Shameer Fareed]

Hi

I'm planning for a CUCM site in France and need some configuration Help

we have 3 sites:

SiteA : 5 T0 lines

SiteB : 3 T0 lines

SiteC: 1 T2

i believe T2 is PRI, can you please share some working configuration for these 2 ISDN types

appreciate your help

Regards

Shameer

[Marc Montouchet]

Hi,

Sorry I was on holidays and couldn't answer your question.

Did you go further on that problem ?

Regards

Marc