Italy Caller ID

[tcamatta]

I have problems with caller id. it is not visualized in my system (UC320W 2.1.4(3) , 3 x SPA303 , SPA8800)

i try this:

reset and reconfigure

update 2.2.2 with factory default and reconfigure

only fxo0 (0 number of line) visualized in spa303

line in UC320W or in SPA8800 is the same

Thank You

Thomas

[Christopher Edgeworth]

Hi Thomas,

Have you tried running the FXO impedance matching on each of your FXO lines.  Go to the FXO screen and select the Impedance matching button.  It will take 7 -9 minutes per line to run.  This helps tune the system to the FXO characteristics.

If you have done the tuning and verified that you can get caller ID by plugging in a analog phone with caller id to the line, then I would suggest contacting the Cisco Small Business Support center where they can run some other diagnostics.

Thanks,

Chris

[tcamatta]

Thank you for support

i will contact Cisco Small Business Support center

Thomas