08-28-2009 12:10 PM - last edited on 03-25-2019 10:41 PM by ciscomoderator
Hi all,
I have several alternate numbers I want to automatically forward to external numbers. Example below:
User calls 555-666-7890 we want it to auto forward to 18005554444
Our PRI is passing through the last 4 digits on our DID's. so the phone system only sees 7890 coming through.
I can't seem to figure out how to do this through the CLI. Can someone offer some assistance?
Thanks,
Jorge
Solved! Go to Solution.
08-28-2009 12:50 PM
Hi Jorge,
You could create a floating ephone-dn (not assigned to any phone) in the CCA safe range. give it the number "7980" and then call forward all to the 1800 destination.
Thanks,
Marcos
08-28-2009 12:50 PM
Hi Jorge,
You could create a floating ephone-dn (not assigned to any phone) in the CCA safe range. give it the number "7980" and then call forward all to the 1800 destination.
Thanks,
Marcos
08-28-2009 01:00 PM
That would work, couple of questions though.
1. What numbers are considered to be in the CCA safe range?
2. How do I go about assigning an external number to the internal extension of the ephone-dn?
This would be my guess...let me know if I am close:
UC520(config)# ephone-dn 65
UC520(config-ephone-dn)# number 199
UC520(config-ephone-dn)# call-forward all 91800XXXXXXX
UC520(config)#voice translation-rule 7
UC520(cfg-translation-rule)#rule 1 /6663/ /199/
UC520(cfg-translation-rule)#exit
UC520(config)#voice translation-profile ExternalService
UC520(cfg-translation-profile)#translate called 7
UC520(cfg-translation-profile)#exit
Thanks,
Jorge
08-28-2009 01:04 PM
Here are the out of band guidelines:
https://supportforums.cisco.com/docs/DOC-9809
You don't need the tarnslation rule. Just configure "number 7980" under ephone DN.
Thanks,
Marcos
08-28-2009 01:14 PM
Odd, when I try to add an ephone-dn with the proper number I get:
UC520(config)#ephone-dn 63
ERROR: could not add peer
Any thoughts as to what could be causing that?
08-28-2009 01:21 PM
What is your max ephone-dn setup to? Under telephony service.
Marcos
08-28-2009 01:52 PM
I ended up just taking an old DN that wasn't associated to anything. It was an old user we deleted and the ephone was deleted as well. Below is the config of the ephone dn but now when I call the number a fax machine picks up....very odd:
ephone-dn 22 dual-line
number 6663
call-forward all 91800XXXXXXX
Any thoughts?
08-28-2009 01:56 PM
Marcos,
Sorry, I had my numbers mixed up, the number is 6662. I adjusted the number on the ephone-dn and now just get a fast busy signal.
ephone-dn 22 dual-line
number 6662
call-forward all 91800XXXXXXX
08-28-2009 02:01 PM
Couple of things to check:
1) Make sure a translation rule is not chaning the inbound DID number to something else.
2) Can you post a debug isdn q931 for the failed call?
Marcos
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide