I had this device configured and operating for 1 week. Dial tone etc.
Today, it has stopped working. Have swapped cabled, factory reset, and cold restart all have the same results.
After a cold restart it is connectable, I can dial #### and get the menu, and I can see it on the network. I can access the web portal to configure.
But this moment is fleeting as after about 10 minutes I cannot see it on the network and I cannot access the voice menu. The only way I can return to an operational state is to unplug it for about 5 minutes and reconnect the power. Once it reestablished DHCP I can see it again.
Lather rinse repeat.
How can I replace this unit?
Thanks in advance,