01-23-2010 04:56 PM - edited 03-21-2019 02:04 AM
Is there a difference in the sytnax required to enter a daylight saving time rule into a SPA400 & a SPA9000?
The rule start=10/1/sunday/02;end=4/1/sunday/02;save=+1 works fine on the SPA9000
This starts DST on the first Sunday of October at 2am and ends it on the first Sunday of April at 2am.
The time shifts forward 1 hour during DST.
If I use this rule in the SPA400 it doesn't store the rule properly.
After rebooting, the rule displays as start=10/1/sunday/02 the end part is missing.
The voicemail message timestamps are one hour out.
NTP is working O.K.
The SPA400 firmware version is 1.1.2.2
Thanks, Nigel
01-25-2010 08:33 AM
Dear Sir;
It looks like your syntax is wrong, as you need to indicate the day of the week in number (1-7) not in name.
e.g. start=4/1/7,end=10/-1/7,save=1
Regards
Alberto
02-01-2010 05:31 PM
Thanks Alberto.
I had 2 problems with the syntax.
First was the "7" for Sunday, not the word.
The second was that the SPA400 uses commas for the delimiters in the daylight savings rule.
The SPA9000 Voice System Administration Guide shows semi-colons as the delimiters.
This rule gives me what I need.
start=10/1/7/02,end=4/1/7/02,save=+1
Regards, Nigel
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide