UC320W as voice only appliance

[jyoopro4ia]

How does one configure the UC320W to only work as a voice appliance? 

I'd like to have a separate firewall (ASA5505) terminating WAN and a POE switch (any recommended model?).

Since the box services both data & voice vlan, do we need setup a trunk port to another switch? (is the UC320W capable of this?)

Any input will be appreciated.  TY

J

[juliomar · Accepted solution]

Hi J,

Yes you can use the UC320W to work as routing Voice only.  You can set the ASA to route Data to WAN.  We have a Smart Design that entails the scenario that you are attempting- though it describes using the SA500, you can use the guidelines to setup using your ASA.

Here is link to UC320W documentation.

https://supportforums.cisco.com/docs/DOC-14783#Smart_Designs_and_Application_Notes

Near the bottom is the document that will guide you with your deployment:

http://tools.cisco.com/s2slv2/ViewDocument?docName=EXT-AS-370391

As for a POE switch, take a look at the Cisco SG300.

Hope this helps you move on right direction.

Best regards,

Julio

[jyoopro4ia]

Julio thanks for the docs.  I will take a look at them.

J