UC520-IP Communicator with SSL VPN

[tazpb2000]

When connected with the Cisco Anyconnect client the IP Communicator will start and register with system correctly. However, I'm not able to make calls with it (don’t get a dial tone) and every 3 minutes or so all the softkeys will disappear and then it will say registering and the softkeys will reload. However, still cannot make a call.

The IP Communicator will work fine on the same computer using the IPSEC vpn client.

Any ideas?

Thanks

[Steven Smith]

What version of IOS are you running?  What version of IP Communicator are you running?  This might be a bug with the SSL VPN, but hard to know without version information.

[tazpb2000]

IOS version: Version 12.4(22)YB4

IP Communicator version 7.0.3.0 running on XP SP3 Pro.

Let me know if you need additional information.

Thanks for your help!

[Steven Smith]

What version of anyconnect are you using?

[tazpb2000]

AnyConnect Version 2.3.2016. I have not upgraded to the latest version because I'm using a self signed cert for testing which I believe will cause problems with the newer version?

All the other programs I've tested work fine over the AnyConnect client (Exchange, RDP, internal websites, file shares, etc).

Jeremy

[Steven Smith]

Would you mind opening a case for this?  I am familiar with one bug on this, but it is fixed on your release (CSCsv64889).

This is probably going to be a bit to difficult to do over the community.