UC520 PRI install

[r-mcconnell]

We have a uc500 base config is with 4FXO 4FXS ports

We need to use a PRI to use some of the UCC functions properly.

I have installed the PRI card but when I login to the system tru the CLI it is asking me to install a licence file?  Where would I get this. I wasn't informed about needing this when we purchased the card.

[Marcos Hernandez]

This is a known issue, please refer to this article that shows how to proceed:

https://supportforums.cisco.com/docs/DOC-9690

Thanks,

Marcos