03-25-2013 10:10 AM - edited 03-21-2019 07:09 AM
Hello ,
I lost the user name and password for UC540
How i can restet the password or make reset factory settings ?
Regards ,
Solved! Go to Solution.
03-25-2013 11:52 AM
Those instructions are pretty detailed.
Let us know if you have any questions.
-Dan
Please rate useful posts.
03-25-2013 08:22 PM
Mohamed,
you need to break that boot-up sequence, so that it bypasses the username config.
eject the flash card, that will put you at ROMON
You can use the following method to recover password.
NOTE** Before breaking into ROMMON, make note of the config register, though its probably 0x2102
1/ Power down the UC
2/ Eject flash card
3/ Power up UC, it will start into ROMMON
4/ at ROMMON1 enter confreg 0x2142 (remember to reinsert the flash card)
5/ type reset (UC will boot, ignoring config)
6/ press N for initial setup prompts
7/ at router prompt type enable
8/ copy startup-config running-config
now you are back in your normal config, so you can modify the accounts, and enable secret
also make sure you bring your interfaces back online, as it will be in shutdown mode.
once you have made all your changes
9/ type config-register 0x2102
10/ then write memory
ALL DONE !!
03-26-2013 01:15 AM
email me your teamviewer details, i will have a look.
03-25-2013 11:52 AM
Those instructions are pretty detailed.
Let us know if you have any questions.
-Dan
Please rate useful posts.
03-25-2013 03:10 PM
When I connect by using putty its asking for user name as you can see below :
Can I give you access by team viewer and help me please ?
03-25-2013 08:22 PM
Mohamed,
you need to break that boot-up sequence, so that it bypasses the username config.
eject the flash card, that will put you at ROMON
You can use the following method to recover password.
NOTE** Before breaking into ROMMON, make note of the config register, though its probably 0x2102
1/ Power down the UC
2/ Eject flash card
3/ Power up UC, it will start into ROMMON
4/ at ROMMON1 enter confreg 0x2142 (remember to reinsert the flash card)
5/ type reset (UC will boot, ignoring config)
6/ press N for initial setup prompts
7/ at router prompt type enable
8/ copy startup-config running-config
now you are back in your normal config, so you can modify the accounts, and enable secret
also make sure you bring your interfaces back online, as it will be in shutdown mode.
once you have made all your changes
9/ type config-register 0x2102
10/ then write memory
ALL DONE !!
03-26-2013 12:13 AM
I failed to reset the passsword
can you please add skype: almodamer911
to give you access by team viwer
03-26-2013 01:15 AM
email me your teamviewer details, i will have a look.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide