05-08-2012 12:06 PM - last edited on 03-25-2019 11:02 PM by ciscomoderator
I have situation where due to where runs are terminating in a facility that we ideally would like to use the Expansion port on our UC540 to connect a
SG300-28P and also have a requirement to connect a second ESW-520-8P directly to the UC540 (to expand the port density past the integrated 8 in this closet to 12). Is this supported via setup in CCA?
Thanks in advance!
Solved! Go to Solution.
05-08-2012 01:26 PM
Yes, under Switching->Smartports change one of the ports to type Switch and default VLAN to 1.
05-08-2012 01:26 PM
Yes, under Switching->Smartports change one of the ports to type Switch and default VLAN to 1.
05-11-2012 08:50 AM
Hello Sorry for interrupting into the thread but just wanted to know if there is any particular model switches that UC-540 supports. I mean i am planning on using the Expansion port to connect to a switch. I am yet to order the switch. Before i do that i was curious if there is any requirement that UC-540 supports only a perticular model of switches or something like that. Thanks.
05-11-2012 10:14 AM
In my case here this was the ESW 500 Series, however with these EoLed you want to look at the 300 Series http://www.cisco.com/cisco/web/solutions/small_business/products/routers_switches/300_series_switches/index.html
which are the replacement for ESW 500 and fully supported in CCA.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide