02-18-2010 10:50 AM - edited 03-21-2019 02:11 AM
Is there something on the 7942 that needs to be configured to have video conferencing? I'm not getting the conference. The camera is working but the video doesn't start when a call is placed.
Solved! Go to Solution.
02-18-2010 02:11 PM
The config is the same. A few things though...
You need to make sure that the version of IP Communicator works with that version of CUVA. I believe you also need to make sure CUVA is setup to work with IP Communicator.
On the phones, you should see a little video camera icon in the lower right corner of the display. Right above the softkeys.
02-18-2010 11:05 AM
Are you calling another local phone with a CUVA? What phone is that?
You need the following to make this work...
config t
ephone 1 (or the ephone that you are using)
video
telephony-service
video
service phone videoCapability 1
no create cnf
create cnf
ephone 1
restart
Do that for both phones you are using.
02-18-2010 02:08 PM
The other phone is CIPC. Is the config the same for it's ephone?
02-18-2010 02:11 PM
The config is the same. A few things though...
You need to make sure that the version of IP Communicator works with that version of CUVA. I believe you also need to make sure CUVA is setup to work with IP Communicator.
On the phones, you should see a little video camera icon in the lower right corner of the display. Right above the softkeys.
02-18-2010 02:37 PM
Steven,
Thank you. Turned out I needed to turn the camera on once the conversation was going under settings of the video screan. I have checked under the video >camera on, for some reason it didn't stay on once a call was initiated. I had this working fine at one point.... things changed? I don't recall needing any CLI before. No matter, as long as it's working.
Thanks once again.
Stephanie
02-09-2011 12:38 AM
Hi everyone,
I have CUCM 7.1.5 and we are trying to make video conferencing with CUVA and 7942g phones. CUVA works fine with 2 users, but when I'm trying to make ad hoc conference or meet me conference the video disappears. On CUCM I have configured Conference Bridge recourses, transcoding and media resources group with list, same thing on a router too. Can somebody please instruct me what do I'm missing here?
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide