cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3854
Views
0
Helpful
1
Replies

Configure SIP with CLI

m.junghage
Beginner
Beginner

Hi!

I'm trying to get the UC500 to work with our SIP providers. Since I'm in Sweden I can't use the fancy preconfigured SIP providers.

I can't get it to work when doing it in the CCA 2.0. I wan't to se exactly how it's setup and if it registers with the provider.

How do I set up a SIP trunk from the CLI?

How to monitor the registration?


In CCA 2.0 you get the option to authenticate on user level instead of digest authentication. Does this mean that I can use a provider that issues usernames and password for each telephonenumber? The provider in this case is Telia.

Thanks!

1 Reply 1

Maulik Shah
Contributor
Contributor

A CLI guide is here:

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_example09186a00808f9666.shtml

Also, you can read section 4.4 at

https://www.myciscocommunity.com/servlet/JiveServlet/previewBody/1560-102-1-1933/UC500-SIPTrunking-Wiki-062008.pdf

Yes you can have a username / password pair per phone number for Registration purposes, support for extending this to INVITEs is on our roadmap.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: