04-10-2013 08:16 AM - last edited on 03-25-2019 11:05 PM by ciscomoderator
Does anyone know how to restrict the UC500 from using specific outbound FXO ports?
Presently they have 2 ports; 1 for fax services and the other for voice services. However the dial plan ignores the port status and will squentially access the ports to send calls outbound. I need to set priority to always send out the voice port FXO line 0/1/3
Ideas?
04-11-2013 07:52 AM
If you are using CCA, check the second tab in the "Outgoing Dial Plan" section. You can specify which ports to use and their hunt scheme.
If you are using CLI, check your trunkgroup settings.
-Dan
Please rate useful posts.
04-11-2013 02:14 PM
Hi Dan;
Thanks for the reply.
I am using CCA and have setup the trunk ports in every possible way (sequential, least active, etc.) but I have been told the UC520 will ignore this and rotate through all the ports. This seems to be the case as I only have 2 FXO ports active and it will choose either for outbound calls. ???
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide