cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
996
Views
0
Helpful
1
Replies

Using UC560 with a SIP Server

Andrez Chavez
Level 1
Level 1

I have an opportunity in which a client needs to interoperate with a SIP server and use the UC560 to route these calls over a T1 circuit. Here is the high level call flow.

Call -> SIP Server -> (inbound) UC560 (outbound) -> T1 circuit

I added the SIP server as a SIP trunk on the UC560. For calls that are made (from the SIP server), the UC560 replies back with a 500 internal error message. The only way I am able to get this to work is as following.

- setup a DID to route to a user

- setup user to forward all calls over the T1 circuit to a external number

This seems like a configuration isuse, but would like some help. At a high level they would essentially want to use the UC560 as a T1 gateway. Is there a way to have the UC560 route all calls from a SIP trunk out to the T1 circuit?

1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

Yes. You will need to configure dial-peer correctly, and possibly voice translation rules.

If you do not have the required experience and certification, you can hire someone that does.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: