Once upon a time this was working fine. Nothing has changed and I am the only admin, and now my SSL vpn just reloads the login page
when I login and registers a clientless VPN session instead of going to load anyconnect (the only enabled connection on the group policy). The realtime log viewer screen cap is attached. No errors, but it appleas the default DAP and goes to webvpn!?!?
webvpn
port 4443
enable outside
dtls port 4443
svc image disk0:/anyconnect-win-2.4.1012-k9.pkg 1
svc enable
group-policy SSLVPN internal
group-policy SSLVPN attributes
dns-server value 192.168.50.11
vpn-idle-timeout none
vpn-tunnel-protocol svc
split-tunnel-policy tunnelspecified
split-tunnel-network-list value SSL_Split_Tunnel
address-pools value SSLVPNPool
webvpn
url-list none
svc keep-installer installed
svc ask enable default svc timeout 5
group-policy DfltGrpPolicy attributes
vpn-idle-timeout none
vpn-tunnel-protocol IPSec l2tp-ipsec svc webvpn
username Adrian password encrypted privilege 15
username Adrian attributes
vpn-group-policy SSLVPN
tunnel-group DefaultL2LGroup ipsec-attributes
pre-shared-key *****
isakmp keepalive disable
tunnel-group SSL-AnyConnect type remote-access
tunnel-group SSL-AnyConnect general-attributes
address-pool SSLVPNPool
