VPN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco CyberSecurity

Labels

Forum Posts

Resolved! IKEv1 & IKEv2

                   I have a 2821 Router with several IPSec Tunnels on it.  I would like to replace this with a ASA 5510.  My hope is to swap these out with minimal impact on the active Tunnels.  I have the details of each Tunnel well documented.  My ...

        I had my ssl vpn working and now the anyconnect client that I downloaded just says Contacting...  It will not give me an error at all.  If I use the Anyconnect App on my droid phone it says "Anyconnect cannot confirm it is connected to your s...

Hi all,Quick question , can I use Windows 7 Native VPN client to connect to the ASA..and are there docs out there that support install and config ?.I heard it is possible but not able to confirm .Many thanks in advanceRabih

r-arzouni by Level 1
  • 756 Views
  • 1 replies
  • 0 Helpful votes

Hi, need help with the following problem. I have created a site-2-site IPSec VPN tunnel. I have used 192.168.183.0/24 as a internal network at remote site.remote site asa configured to allow all traffic  from this range. i.e.access-list xxx extended ...

nushrat88 by Level 1
  • 863 Views
  • 5 replies
  • 0 Helpful votes

Hi Experts,Is the above statement true?. I learnt later that adding tcp and udp ports on the nat 0 statements are supported . But does it take away the entire nat statement? Please answer my question at the earliest.RegardsKrishna

Hi All, We are upgrading from Windows XP to windows 7 , windows XP uses cisco VPN Client 5.0.07.0410 with start before logon ( SBL ), I have few questions1) what is the equivalent client for windows 7 ( anyconnect ??? ) and what version we should be ...

r-arzouni by Level 1
  • 3176 Views
  • 1 replies
  • 0 Helpful votes

I have been using QUICKVPN   client for years to connect my laptop to my office network. the laptop previously had XP as a OS. i had set my laptop workgroup to match the network and connect to outlook, map drives and dowload files.i had to upgrade to...

Hi All,We are currently experiencing a problem on an IP SEC VPN tunnel that has all of us here completely stumped. We are hoping that one of you experts out there will be able to assist. Here are some basic details:NETWORKSAn IPSEC site to site tunne...

veltech by Level 1
  • 2185 Views
  • 7 replies
  • 0 Helpful votes

Hi,I have been trying to get the AC 3.1.00495 work with OS X 10.8.2. If the connection has split configuration everything works just fine. However full tunnel, tunnel everything, doesn't work at all. Client can't verify routing table changes and so f...