Hello,
We have site-to-site VPN tunnels setup between our ASAs using VTIs. However, the VTIs do not show any traffic statistics (e.g. 1 minute input rate, packets dropped, packets input, etc...).
This is what I see:
asa# show interface tunnel 1
I...
After updating one of our Mac OS computers to the latest update Mojave 10.14, Hostscan can't detect the if the Mac firewall is on or not. It did detect it correctly before the new update. Now it doesn't even print anything about the firewall in the c...
Hey everyone, its great to be part of this community. I have searched on this site before for help, but this is my first post. I am currently going to school for networking and I am having a problem on one of my labs.
Scenario.... Router 1 has 2 sw...
Hi,
I have had to replace a ISR 4331 which has a field notice replacement against it.
The router basically provides an IPSec Tunnel over a WAN circuit to another site while routing OSPF on top.
I installed the same version of software on the replac...
I have an IPSEC VPN configured that the user has no problems with except:When she is using Remote Desktop from location H to location Q, she wants to be able print back to H. The printer in H goes offline about 15 seconds after the VPN connection is ...
Hi guys.
We have an ASA in Central office and is connected using site to site VPNs with the Branch Offices where we have Cisco 800 Series Routers.
We have 3 specific branch offices which are connected with each other using Site to Site VPNs and now...
I have 2 routers and want to configure site to site IPSec tunnel between them by enrolling to different sub-CA trustpoints in each router. These sub-CA's have common root CA
eg:
root CA - SubCA1
root CA - SubCA2
is the hierarchy
configuration in ...
Good Afternoon,
I just upgraded to the 4.6.01 of AnyConnect and now when user are access the LAN remotely everything is very slow. Most site are taking up to 500ms to connect. Some of the site are not available to connect because of the time delay....
We have migrated from Cisco ACS TACACS+ to Cisco ISE TACACS Device Administration. We were able to search for network devices within ranges on the old system but not with ISE. For example, in the old system if you had 10.10.10.7-10, you could search ...
Has any one got a working setup for SSL VPN users in regards to notification about password is going to expire and then providing the VPN user the opportunity to change password during the VPN login process, involving ASA5520 - ACS Radius server - Ac...
Hello, I have a working 2 (3)-factor authentication with AnyConnect. Basic is set up with method 'AAA and certificate', and AAA Server Group is my AD-servers. Secondary configuration is set using my radius-server (Gemalto Safenet). Safenet is sending...
Has anyone ever had this happen. I have the configuration correct, because it works for a spell.Then after a certain amount of time it stops working and does not automatically begin.
So here is the scenario:
I have a site to site configured. I have ...
After upgrading cyberoam to newest software, we experiencing problems with IPSec connection.For example: Phase 2 of vpn is disconnecting every 30,40 or 60 seconds regulary for half a day. On the other half, it works OK without any problems. Problem o...
I have an issue with Phase 2 connecting to AWS VPN. Been banging my head for days.. please help
Error log https://imgur.com/elY9GZ8
show crypto ipsec sa peer https://imgur.com/t0wkRhv
I see no decaps..
Config below, any help appreciated...supe...
