Can't ping outside redundant vlan subinterface

[cmclan2121]

Can't ping outside ip. Checked config. guide and all seems in order. Am I missing something here to make redundant interface work ?

ASA 5550 VPN Premium license

Cisco Adaptive Security Appliance Software Version 8.3(2)

Device Manager Version 6.3(5)

Here is my "show running-config interface" output:

interface GigabitEthernet0/0

no nameif

no security-level

no ip address

interface GigabitEthernet0/2

no nameif

no security-level

no ip address

interface Redundant1

member-interface GigabitEthernet0/0

member-interface GigabitEthernet0/2

no nameif

no security-level

no ip address

!

interface Redundant1.251

vlan 251

nameif outside

security-level 100

ip address "outside_ip" 255.255.255.0

[cmclan2121]

Can it be beacause internal-data0/0 status is down ?

show interface ip brief

Interface                  IP-Address      OK? Method Status                Protocol

GigabitEthernet0/0         unassigned      YES unset  up                    up 

GigabitEthernet0/1         unassigned      YES unset  administratively down down

GigabitEthernet0/2         unassigned      YES unset  up                    up 

GigabitEthernet0/3         unassigned      YES unset  administratively down down

Internal-Data0/0           unassigned      YES unset  administratively down up 

Management0/0              "mgnt_ip"   YES CONFIG up                    up 

GigabitEthernet1/0         unassigned      YES unset  administratively down down

GigabitEthernet1/1         unassigned      YES unset  administratively down down

GigabitEthernet1/2         unassigned      YES unset  administratively down down

GigabitEthernet1/3         unassigned      YES unset  administratively down down

Internal-Data1/0           unassigned      YES unset  up                    up 

Redundant1                 unassigned      YES unset  up                    up 

Redundant1.251             "outside_ip"  YES manual up                    up

[cmclan2121]

If I configure ip and sec-level on "redundant 1" without vlan then ping works.

But this is not my goal ...

interface Redundant1

member-interface GigabitEthernet0/0

member-interface GigabitEthernet0/2

nameif outside

security-level 100

ip address "outside_ip" 255.255.255.0

[cmclan2121]

Answered this myself

Trunk and 802.1q was not configured on uplink port of the access switches ...

Feel like I'm talking to myself here ... lol

[Shelley Bhalla · Accepted solution]

lol .. please mark thi thread complete as well.

Shelley

Cisco.